When running "boot to PXE" or "boot to automation" from the console, it is common to see this coming up on the client machine instead of WinPE:
This will result in a LOOP as the client will boot into Production and then the "boot to PXE" or "boot to automation" task will be picked up again until it times out.
Please check the BIOS Boot Setup; very likely "Network Boot" is NOT set as FIRST:
So to correct this, please modify to:
and the client should now boot into WinPE 4.0 as sequence below:
NOTE:
If you found the above information useful, please give this article a thumbs-up(top right of the post) or add a comment below. Your feedback will help our tech community – Thank you, Mauro